Ruth's sister V6 Heatbreak 1.75mm M7 37.6mm internal power cable
All-metal heatbreak with M7 thread for 1.75mm filament and 37.6mm total length
- All-metal construction withstands high printing temperatures
- Smooth inner bore reduces filament clogging during extrusion
- M7 thread fits E3D V6 hot-end assemblies directly
- Designed for 1.75 mm filament compatibility
- 6 mm total length matches standard heat-break dimensions
Compatible Heatbreak for E3D V6 Hotends
This all-metal heatbreak fits E3D V6 hotends and volcano heat blocks. It accepts 1.75mm filament and uses an M7 thread. The total length is 37.6mm, matching the threaded specification for these printers.
Integration With Extruder Assembly
The heatbreak threads into the heater block and seats inside the heatsink. Its smooth inner wall reduces filament friction and helps prevent clogging during prints. No additional adapters are required when replacing a worn or damaged heatbreak on a compatible V6 setup.
Thermal Performance and Power Draw
All-metal construction withstands high printing temperatures without deforming. The component itself draws no power and adds no active cooling noise. It relies on the printer's existing heatsink fan to maintain a sharp thermal transition between the cold and hot zones.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $10.99
- Cheaper than about 70% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How hot can the all-metal heatbreak get before the PTFE tube fails?
The heatbreak is all-metal with no PTFE liner, so it handles the full hot-end temperature range of your V6 heater block.
Will the M7 thread fit my existing V6 heatsink without cross-threading?
The M7 thread matches the standard V6 heatsink interface; screw it in by hand until snug, then tighten gently with a 7 mm spanner.
Does the 37.6 mm length match the stock heatbreak on my Prusa i3 MK3?
Yes, the 37.6 mm threaded length is the same as the original E3D V6 heatbreak used on the MK3.
More in Internal PSU & Riser Cables
Similar items
Nippon Labs POW-04412 12" Molex 5.25 Female to Female internal power cable
- 1 ft (0.3 m)
- Multi-Color
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Ruth's sister JEYI Heat Sink 7mm Ultra-thin Solid State Hard Disk Heatsink internal power cable
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





