Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Genuine 300 dpi printhead for Sato CL412 and CL412E thermal label printers, fully tested before shipment
This genuine Sato printhead carries part number GH000771A and is built for the CL412 and CL412E thermal label printers. It arrives new and fully tested before shipment. The component is intended for technicians and operators who maintain these specific Sato models and need a direct replacement.
The head is rated for 300 dpi output and is validated at 100 percent testing to maintain consistent density across long label runs. Thermal elements are matched to the printer firmware so extended batches do not drift. No installation guide is included, so the installer must already know the alignment procedure.
The single specification that determines compatibility is the 300 dpi resolution matched to the CL412 and CL412E series. A 305 dpi variant exists but is a different part and will not work in these printers. Buyers who need a different resolution or a different printer family cannot use this head.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product category | Printhead |
The printhead is a passive thermal component with no moving parts, so it generates no audible noise and only the heat required for 300 dpi thermal transfer.
You need a compatible Sato CL412 or CL412E printer, basic hand tools for the printhead latch, and the skill to align the new head without an included guide.
Yes, the 300 dpi resolution matches the CL412 specification, so existing 300 dpi media and ribbons remain fully compatible.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?