Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Genuine 300 dpi thermal printhead restores sharp barcode output on CL412E label printers
This is a genuine Sato replacement printhead bearing part number GH000771A. It is designed specifically for the Sato CL412 and CL412E thermal label printers operating at 300 dpi resolution. The unit is supplied new and includes a single thermal printhead ready for installation.
This printhead suits technicians and operators maintaining a Sato CL412 or CL412E printer already configured for 300 dpi output. It is not suitable for printers set to a different print resolution or for other Sato printer models that require a different part number.
The decisive specification is the manufacturer part number GH000771A, which identifies this printhead exclusively for the Sato CL412 and CL412E series at 300 dpi. Verifying this part number against the printer service manual is the only way to ensure the correct component is ordered.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Power off the printer, open the printhead latch, remove the old head, seat the new GH000771A firmly, close the latch until it clicks, then run a calibration so the 300 dpi alignment registers correctly.
Clean the printhead with isopropyl alcohol and a lint-free swab after every roll change; replace it when print quality degrades or after the rated dot-life is reached.
Heat buildup in the thermal elements causes temporary fade or dot dropout before mechanical wear becomes an issue.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?