Kingston Technology Corp. KSM56R46BD8PMI-48MBI 48GB DDR5-5600 CL46 2Rx8 Registered server RAM
- 48 GB
- DDR5 5600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
8 GB DDR4-2400 LRDIMM with ECC and registered buffering for server stability
The SK hynix HMA81GR7AFR8N-UH is an 8 GB DDR4-2400 LRDIMM built for registered ECC server platforms. Its load-reduced architecture lowers electrical loading on the memory bus, allowing higher capacities per channel. The module operates at 1.35 V and uses a 288-pin interface with a 1Rx8 organisation. It suits administrators who need reliable error-correcting memory for virtualisation hosts or database nodes.
Running at the standard 1.35 V, the module draws modest power and generates little heat without a heat spreader. Passive airflow inside a typical server chassis is sufficient to keep temperatures within specification. The registered buffer adds negligible latency while stabilising signal integrity across fully populated channels. Acoustic impact is zero because the component has no moving parts.
The 288-pin form factor fits any DDR4 RDIMM/LRDIMM slot wired for registered operation. Systems must support load-reduced DIMMs and ECC; consumer or unbuffered platforms will not recognise the module. Mixing with standard RDIMMs is not supported by most server chipsets. The single-rank design leaves additional rank slots open for future capacity expansion within the same channel.
Measured against everything we stock in ECC Server RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Align the notch with the slot key, press firmly until both latches click, then verify the 1.35V setting in BIOS so the module runs at its rated DDR4-2400 speed.
No routine maintenance is required; replace only if memory diagnostics report correctable ECC errors rising or the module fails to train at DDR4-2400 after reseating.
The 1.35V operating voltage and single-rank 1RX8 organisation cap sustained throughput at the rated PC4-2400T data rate before thermal or signal margins become a factor.
More in ECC Server RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?