Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 0.5 metre low-profile cable splits one SFF-8654 8i 74-pin host port into eight SATA ports using 30 AWG copper and 100 ohm impedance control for dense server storage expansion
This 0.5 metre harness converts a single SFF8654 LP 74Pin host port into eight independent SATA connections, letting builders expand storage in slim servers or dense rackmount chassis without adding controllers. The lowprofile form factor keeps internal routing tidy in spaceconstrained OEM systems and RAID backplanes.
Premium 30AWG copper wire with 100ohm impedance matching preserves clean PCIe and SAS transmission across the short run, reducing attenuation and crosstalk during heavy multiharddrive workloads. The halfmetre length supports neat cable management inside compact server enclosures.
Replaces bulkier multiport assemblies when a single SFF8654 8lane port must feed eight SATA drives in a tight chassis. The jump is worthwhile whenever density matters more than reach and the host already exposes the required lowprofile connector.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Align the low-profile 74-pin plug with the host port keying, press straight in until the latch clicks, then route the 30AWG wires without sharp bends to reach the eight SATA drives.
Inspect the 100-ohm impedance traces and 30AWG copper conductors for kinks or connector wear when drives are swapped; replace the harness if signal errors appear.
The 0.5M length and 30AWG gauge set the practical attenuation ceiling for multi-drive SAS/SATA streams before signal margin drops.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?