Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects one SFF8654 38pin SAS 4.0 host port to four SFF8482 29pin SAS drives with a 100cm fanout cable for RAID arrays
This SMUGDESK cable is a 1-to-4 fan-out splitter that converts a single SFF8654 38-pin Slimline SAS 4.0 host port into four SFF8482 29-pin SAS target ports. It is built for administrators and integrators expanding drive counts on RAID controllers inside rackmount servers and storage enclosures. The 100cm length supports flexible routing in dense chassis.
It suits builders connecting up to four SAS hard disks to one modern Slimline SAS 4.0 RAID adapter in enterprise or data-centre deployments. It is not for installations where the host side uses a different connector type or where fewer than four target ports are required. Systems lacking an SFF8654 4-lane host interface cannot use this cable.
The host connector is an SFF8654 38-pin Slimline SAS 4.0 4-lane port; the four drive connectors are SFF8482 29-pin SAS ports. Verify that your RAID controller presents exactly this host interface and that your drives or backplanes accept the SFF8482 attachment before ordering.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The SFF8654 38pin host port follows the SAS 4.0 specification, providing four lanes of highspeed data transmission for stable multidrive connectivity.
The 100cm length allows flexible routing between the RAID controller and four SFF8482 29pin drive bays in large enclosures.
Connect the single SFF8654 38pin plug to the RAID host port, then attach each of the four SFF8482 29pin connectors to the target drives, ensuring every latch clicks securely.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?