Tripp Lite U026-016 USB 2.0 Active Extension Cable 16 ft
- USB A to USB A
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Two 11-inch USB-A female to bare-wire pigtails deliver 5 V 3 A power for DIY repairs and custom builds
This two-pack supplies 11-inch USB-A female to bare-wire pigtails built for power-only connections. Each cable carries 5V at up to 3A using tinned copper conductors inside a flexible jacket. Pre-stripped ends let you solder directly to boards or modules without extra prep. The design targets technicians and hobbyists replacing damaged ports or powering custom circuits.
Power-only wiring means no data signalling, so the cable runs cool during typical 5V loads. The tinned copper cores keep resistance low, limiting voltage drop across the short 11-inch run. No active cooling or fans are involved, so operation is silent. Current capacity stops at 3A, matching the rated output for small USB-powered devices.
Exposed conductors eliminate the need for stripping tools and reduce installation time inside tight enclosures. The flexible jacket resists bending fatigue when routed through equipment housings. Two cables in the pack provide a spare for testing or a second repair job. Data lines are absent, so the cables cannot be used for communication or firmware updates.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Solder the pre-stripped tinned copper wires directly to the power pads on your circuit board or power module, then secure the short cable with adhesive or cable ties to prevent strain on the joints.
Inspect the solder joints and flexible jacket periodically for cracks or loosening caused by vibration or heat cycles; replace a cable if the insulation is damaged or resistance rises.
The 5V 3A rating is the hard ceiling; sustained draws near that level will cause voltage drop and heating in the thin conductors before any other factor becomes an issue.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?