Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Fanout cable splits one SFF-8654 74-pin SlimSAS 8X port into two SFF-8643 36-pin MiniSAS HD 4X ports for Broadcom RAID controllers and NVMe storage arrays
This professional cable converts a single SFF8654 74pin SlimSAS 8X port into two independent SFF8643 36pin MiniSAS HD 4X connections. It serves as a direct replacement for Broadcom MPN 056000300 and is fully compatible with Broadcom RAID controllers and server hardware. The design targets enterprise servers, storage backplanes and highdensity enclosures that require reliable highspeed SAS and NVMe connectivity.
The servergrade shielded construction minimises signal loss across the 80cm length, preserving ultrahighspeed transmission without active components or external power. As a passive copper cable it adds no heat or audible noise to the chassis, leaving thermal and acoustic profiles entirely dependent on the host system. Power draw is negligible and limited to the signalling lines provided by the controller.
The 80cm optimised length supports flexible routing inside rackmount servers and storage arrays while the SFF8643 MiniSAS HD latching connectors resist vibration induced disconnects. Each fanout leg terminates in a standard 36pin interface compatible with common backplanes and drive cages, simplifying cable management in crowded chassis. Buyers who need a singleport SlimSAS cable or a different lane split will require an alternative part.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Align the 74pin connector with the host port keying and press firmly until the latch clicks; then seat each 36pin connector into its backplane or drive cage port, verifying both latches engage.
The cable has no moving parts or consumable elements; replace only if physical damage, connector wear, or signal errors appear during diagnostics.
Signal integrity over the 80cm shielded run is the limiting factor; the design targets low loss so the link remains stable at rated speeds.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?