Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects SFF-8654 4i to U.2 NVMe drives with integrated SATA power, delivering 30 Gbps PCIe 5.0 bandwidth over 1 m low-loss copper
The SMUGDESK Gen5 MCIO cable converts an SFF-8654 4i interface to an SFF-8639 U.2 port while supplying drive power through an integrated 15-pin SATA connector. This single assembly carries both PCIe 5.0 data and power, reducing internal cable count in servers and workstations. It is built for new deployments where U.2 NVMe SSDs connect to modern backplanes or controller cards.
This harness suits installers who need a 1-metre, 30 Gbps link with combined data and power for U.2 drives in dense chassis. It does not fit systems that require a longer reach or a separate power cable routed to a different PSU connector. Builders using SFF-8654 8i or other wide-port controllers cannot use this 4i version.
The cable is rated for 30 Gbps bandwidth, matching PCIe 5.0 signalling across the SFF-8654 4i to SFF-8639 U.2 link. If the target controller or backplane operates at a lower generation, the link will train down, but the 30 Gbps ceiling is the figure that confirms Gen5 readiness.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
It converts an MCIO SFF-8654 4i host port to a U.2 SFF-8639 drive connector and adds a 15-pin SATA power plug so the drive receives both data and power from one harness.
The harness is built for PCIe 5.0 signalling, so a Gen5 U.2 NVMe SSD can sustain its full 30 Gbps link speed through the one-metre copper run without a separate power cable.
The 4i connector carries four PCIe 5.0 lanes, capping the link at 30 Gbps; the cable’s low-loss 30 AWG copper and shielding preserve that bandwidth across the full metre length.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?