Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects an MCIO SFF8654 4I port to a U.2 SFF8639 drive with integrated 15-pin SATA power, delivering 30Gbps over .5M premium copper
This 0.5 metre harness links a Gen5 MCIO Slimline SFF8654 4I port to an SFF8639 U.2 NVMe drive while delivering power through an integrated 15 pin SATA connector. It targets server builders and storage integrators who need a direct, single cable solution for adding U.2 solid state drives to enterprise backplanes or RAID controllers. The short length keeps internal routing tidy in dense chassis where space is at a premium.
Passive copper construction generates no heat of its own and adds no acoustic noise to the system. The cable simply conducts the 30 Gbps signal and the auxiliary 15 pin SATA power lines between the host and the drive. Power consumption is limited to the negligible resistive loss of the conductors, leaving the drive and controller to determine the overall thermal envelope.
No software, drivers or additional adapters are included; the cable is a pure hardware interconnect. The integrated 15 pin SATA power plug removes the need for a separate power lead or Y splitter, reducing cable count and potential failure points. Builders gain a cleaner harness and faster deployment in storage arrays, servers and data centre expansion projects.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Route the .5 m harness from the MCIO 8654 4I port to the U.2 8639 drive bay, seat both data connectors firmly, then attach the 15-pin SATA power plug to a free SATA power lead from the PSU; the drive will not spin up without that power connection.
The 15-pin SATA power connector and the latch tabs on the MCIO 8654 and U.2 8639 ends endure the most insertions; if a latch snaps or a pin bends, replace the whole .5 m harness rather than re-pinning.
The assembly is rated for 30 Gbps; continuous workloads that saturate that bandwidth — such as multiple U.2 NVMe drives streaming large sequential writes — will reach the cable's signalling ceiling before any other component.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?