SMUGDESK LP4 4 Pin IDE Male to 5 SATA Female Power Splitter Cord 18AWG 24cm
Converts one legacy IDE power port into five SATA connectors for 2.5 and 3.5 drives using 18AWG wire over a 24cm length
- Converts one legacy IDE port into five SATA power connectors
- 18AWG thick gauge wire delivers stable power with minimal voltage drop
- 24cm length allows tidy internal routing without excess cable clutter
- Molded connectors lock firmly to prevent accidental power loss from vibration
- Powers 2.5 SSD, 3.5 HDD and optical drives with standard SATA 15Pin interfaces
LP4 IDE to SATA power splitter
This cable converts a single 4-pin LP4 IDE power connector into five SATA power ports, allowing older power supplies to drive multiple modern storage devices. It suits builders upgrading legacy systems or adding drives to chassis with limited SATA power outputs. The 18AWG conductors support stable current delivery across all connected drives.
Thermals noise and power draw
The 18AWG copper conductors minimise voltage drop under normal working loads, reducing resistive heating inside the case. Flame-retardant insulation protects the wires from abrasion and ambient heat in enclosed chassis. As a passive cable it generates no audible noise and draws no power beyond what the attached drives require.
15-pin SATA device compatibility
Each of the five female connectors accepts the standard 15-pin SATA power interface found on 2.5 SSD, 3.5 HDD and optical drives. The moulded connectors lock firmly to prevent accidental disconnects caused by vibration. Total connected device consumption must remain within the power supply's rated load for safe operation.
How it compares
Measured against everything we stock in Y-Splitter Power Cables, at today’s prices. Recalculated every night.
- Price $12.99
- Cheaper than about 60% of the 428 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How do I connect the LP4 4 Pin IDE male connector to my power supply, and what is the common mistake?
Plug the LP4 male end firmly into the power supply's IDE port until it clicks, then attach up to five SATA drives. The step often missed is seating each SATA connector fully so the latch engages, preventing power loss from vibration.
Will the 18AWG wire or the molded SATA connectors need replacement over time?
The 18AWG copper conductors and flame-retardant insulation are built for long-term operation inside a chassis. The durable molded connectors resist loosening from vibration, so no scheduled maintenance or connector replacement is required under normal use.
What is the first limit I will hit when running five drives on this 24cm splitter?
The total power draw of all connected drives must stay within the power supply's rated load for the IDE rail. Exceeding that limit will cause instability before the cable's 18AWG gauge or 24cm length becomes a factor.
More in Y-Splitter Power Cables
Similar items
Cable Matters 4 Pin Molex to Dual 15 Pin SATA Power Y-Cable Splitter Adapter 2 Pack 8 inch 18AWG
- DVI to DVI
- Female to Female
4XEM 4XHDMIVGA10FTU 10ft HDMI to VGA adapter cable with USB power
Cable Matters 10-in-1 USB to DC 5.5×2.1mm Power Splitter Cord 5ft
- DVI to DVI
- Female to Female
Shenzhen Aimilai Technology Co.Ltd. 12-Way 5V RGB LED Splitter Hub with PMMA Case and Magnetic Standoff
Cable Matters SATA to 2×3/4-pin PWM fan power splitter cord 4pcs
- DVI to DVI
- Female to Female





