Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A .5 m MCIO SFF8654 8i 74Pin cable breaks out to eight 90° SATA connectors using 32AWG copper for dense server storage
This .5 metre cable splits a single 74pin MCIO SAS SFF8654 8i connector into eight 90degree SATA 7pin female ports. It is built for server and NAS builders who need to attach multiple hard drives or SSDs to a highdensity backplane without long cable runs. The 32AWG copper conductors and heavy shielding keep signal integrity stable across all eight lanes.
The rightangle SATA ends prevent bending stress in tight chassis and remove the clutter of individual straight cables that block airflow. The jump is worth it when a backplane or controller presents the 8i MCIO interface and you need a clean, short harness for eight drives at once. It replaces a bundle of separate cables with one managed assembly.
Each SATA 7pin port carries a single 6 Gbps link, so total throughput is bound by the eight independent SATA channels rather than the wider MCIO pipe. The .5 metre length suits rackmount trays but will not reach between widely separated enclosures. Shielding reduces crosstalk, yet the cable cannot overcome the inherent bandwidth ceiling of the SATA standard itself.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The right-angle SATA 7-pin female connectors project sideways from the drive, so allow roughly the connector body width plus a few millimetres for the 32AWG cable bend radius in tight backplanes.
Push the SFF8654 8i MCIO connector straight into the motherboard or controller until the latch clicks, then press each 90-degree SATA head onto its drive port until fully seated — do not force at an angle.
Replace if the 32AWG conductors show kinks, the shielding is torn, or any SATA latch fails to hold; otherwise the passive copper assembly has no wear-out schedule.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?