Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts a single SFF8644 Mini SAS HD port into four 90-degree SATA 7-pin connectors with an integrated signal-conditioning IC for stable 6Gbps data transfer across SATA drives and RAID controllers
This cable converts a single SFF8644 Mini SAS HD port into four 90‑degree SATA 7‑pin female connectors. It is intended for system builders expanding storage in servers, workstations or JBOD enclosures. The integrated signal‑conditioning IC helps maintain data integrity over the full run. Each SATA port supports standard hard drives and solid‑state drives at 6Gbps.
Passive copper conductors and the onboard IC add negligible heat inside the chassis. No active cooling or extra power connectors are required, so the cable does not increase system fan speed or acoustic output. The 28AWG pure copper wire keeps resistive losses low during continuous 6Gbps transfers. Power consumption remains limited to the drives attached at the SATA ends.
Right‑angle SATA plugs sit flush against drive backplanes, easing cable routing in tight rackmount bays. The 1‑metre length provides enough slack for tidy internal runs without excess loops. Latching SFF8644 and SATA connectors resist accidental disconnection during vibration or drive swaps. Shielded construction with the IC chip suppresses electromagnetic interference in dense multi‑drive arrays.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Insert the SFF-8644 plug into the RAID controller port until it clicks, then press each 90-degree SATA connector straight onto the drive backplane; the common mistake is angling the right-angle plugs, which bends the 28AWG pins.
The integrated signal-conditioning IC and 28AWG copper conductors require no scheduled maintenance; replace the cable only if the latch on the SFF-8644 end breaks or a SATA port feels loose after repeated drive swaps.
The 28AWG gauge and 1-metre length set the practical ceiling; beyond that distance the IC cannot fully compensate for signal loss, so throughput drops before the 6Gbps spec is reached.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?