Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects MiniSAS HD SFF8644 to QSFP 40G SFF8436 for 12Gbps SAS 3.0 server stacking with 28AWG copper and 10ohm impedance
This 1 metre cable bridges MiniSAS HD SFF8644 and QSFP 40G SFF8436 ports for server stacking, RAID controller attachment and JBOD expansion. It targets administrators building high density storage fabrics or aggregating compute nodes in enterprise racks where 12Gbps SAS 3.0 throughput is required.
Twenty eight AWG copper conductors with controlled ten ohm impedance preserve signal quality across the link while supporting 12Gbps data rates. The shielded black jacket reduces crosstalk and electromagnetic interference in densely populated chassis without adding bulk that would restrict airflow.
The one metre reach allows tidy routing between adjacent rack units, between a controller and a shelf or across a short intra rack gap. Both connectors use industry standard latch mechanisms so the link stays secure during vibration or hot swap maintenance in production environments.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Align the MiniSAS HD SFF8644 connector with the controller port and the QSFP 40G SFF8436 end with the switch or storage port, then press both straight in until each latch clicks; the step often missed is verifying both latches are fully seated before routing the cable.
No scheduled maintenance is required; inspect the 10ohm impedance-controlled conductors and shielding during rack audits and replace the cable only if physical damage or signal errors appear on the 12Gbps SAS 3.0 link.
The 28AWG copper construction and 10ohm impedance matching set the practical ceiling; sustained 12Gbps throughput is supported, but signal integrity degrades if the cable is bent tighter than the shield allows or if connector latches loosen under vibration.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?