Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a PCIe 4.0 Slimline SAS SFF8654 4i port to four 90° SATA drives using 30AWG copper for stable high-speed data transfer
This SMUGDESK harness converts a PCIe 4.0 Slimline SAS SFF8654 4i 38pin connector into four 90degree female SATA ports. It is designed for administrators expanding storage inside enterprise servers, RAID arrays or multi-drive systems using existing Slimline SAS backplanes or controllers.
The cable uses 30AWG pure copper conductors and anti-interference shielding for stable high-speed data transfer. Each 90degree SATA connector reduces the bend radius behind drives, making daily cable routing practical in dense chassis where straight plugs would block adjacent bays or airflow paths.
Before ordering, verify that your host controller or backplane presents a Slimline SAS SFF8654 4i receptacle rather than a different pin-count or keying. Confirm that target drives accept standard SATA data connectors and that separate power cables are available, as this harness carries data only.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The cable is PCIe 4.0 compliant and converts a single SFF8654 4i 38pin connector into four SATA ports, so each SATA device runs at up to 6 Gb/s while the upstream link carries up to PCIe 4.0 x4 speeds.
Each female SATA plug uses a right-angle 90degree design that keeps the cable close to the drive, allowing tight routing in compact enclosures without blocking adjacent bays.
Connect the SFF8654 4i end to the controller or backplane, then plug each 90degree SATA connector into the drive; the step often missed is fully seating the Slimline SAS latch until it clicks, otherwise the link will not train at PCIe 4.0 speeds.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?