Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects SAS controllers to SATA drives with integrated Molex power, SATA III 3.0 compliant, 30 cm length, two cables included
This SFF-8482 cable converts a 29-pin SAS controller port to a standard 7-pin SATA III interface, letting you attach SATA hard drives or SSDs to SAS RAID cards and host bus adapters. Each pack contains two 30cm cables, providing enough reach for internal wiring in compact chassis or NAS enclosures. The female-to-female design creates a direct link between the controller and the drive without extra adapters. It is intended for builders assembling RAID arrays or expanding server storage with SATA media.
An LP4 4-pin Molex connector is moulded into the cable assembly so the attached drive receives dedicated power, reducing the chance of spin-up failures or drive drops under load. The signal path follows the SATA III 3.0 specification, preserving full throughput for mechanical and solid-state drives alike. Because the cable carries both data and auxiliary power, it frees up motherboard SATA power headers and simplifies cable routing in tight drive bays. No additional power splitters are required for typical single-drive connections.
The cable itself is passive and generates no measurable heat or acoustic noise during operation. Power draw is limited to whatever the connected SATA device requires, delivered through the Molex pins from the host power supply. Securely moulded connectors resist vibration-induced signal loss, helping maintain stable operation in continuously running storage servers. No active cooling or fan headers are involved.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The 30cm length gives about 11.8 inches of slack for routing inside a case or NAS enclosure.
The LP4 4-pin Molex tap feeds the drive directly from the PSU, so the drive gets full rail current without loading the SAS controller.
A standard LP4 4-pin Molex lead from the PSU is required to power the attached SATA drive.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?