Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts SAS 8482 to SATA 3.0 with integrated LP4 Molex power, 30 cm length, pack of 2
This SMUGDESK cable converts an SFF-8482 SAS 29Pin interface to a standard SATA III 7Pin connector for connecting SATA hard drives to SAS controllers. An integrated 4Pin LP4 Molex port supplies drive power through the same assembly. The female-to-female design enables direct interconnection without additional adapters. Each pack contains two cables for multi-drive configurations.
The cable complies with the SATA 3.0 standard for 6Gbps transmission speed between the host adapter and the attached drive. Signal integrity depends on the 30cm length and shielding quality to reduce interference in dense chassis environments. Actual throughput is constrained by the slowest device in the link, whether the SAS controller or the SATA drive. No protocol conversion beyond physical pin mapping is performed.
The fixed 30cm (11.8 inch) length determines whether the cable reaches between your controller port and drive bay in a given chassis. Longer runs require a different cable; shorter runs leave no slack for cable management. Measure the internal routing path before ordering to confirm the 30cm reach suits your server, NAS or surveillance recorder layout.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
This cable uses the SFF-8482 standard, converting a 29-pin SAS connector to a SATA 3.0 7-pin female port with an integrated 4-pin LP4 Molex power plug, so it matches controllers and backplanes that expose the 29-pin SAS interface.
The cable supports the SATA III 6 Gbps signalling rate, allowing a SATA hard drive or SSD to run at its native speed when connected to a SAS host adapter or RAID controller through this adapter.
It complies with the SATA 3.0 specification, which limits the data path to 6 Gbps, while the SAS side uses the SFF-8482 29-pin form factor for compatibility with SAS controllers and backplanes.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?