Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts one SFF8643 host port into four 29pin SFF8482 drive connections for 12Gbps SAS 3.0 storage expansion
This SMUGDESK breakout cable converts a single internal SFF8643 host port on a RAID or HBA controller into four independent SFF8482 29pin drive interfaces. It enables direct connection of up to four SAS or SATA hard drives inside rackmount servers and workstations. The design targets administrators expanding storage capacity through JBOD or RAID array deployments.
Shielded internal wiring suppresses electromagnetic interference and crosstalk to maintain stable 12Gbps SAS 3.0 signalling during simultaneous multi-drive operation. Both the SFF8643 and SFF8482 connectors feature locking latches that resist disconnection caused by chassis vibration or cable movement. The fanout layout reduces internal clutter to support unrestricted chassis airflow.
The cable operates at 12Gbps per channel and remains compatible with 6Gbps and 3Gbps SAS and SATA drives for mixed-mode environments. It is built specifically for host-to-drive direction; the SFF8643 end attaches to the controller while the four SFF8482 ends attach to drives. No additional software or drivers are required for the physical link.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Connect the SFF8643 end to the RAID or HBA controller first, then attach each of the four 29pin SFF8482 connectors to the SAS drives until the locking latches click; the step people miss is not fully seating both latches on every connector, which can cause drive dropouts under rack vibration.
The shielded wiring and locking latches are designed for continuous server operation; no scheduled maintenance is required, but inspect latch integrity if drives are swapped frequently and replace the cable if any latch fails to snap securely.
Each of the four channels is capped at 12Gbps per the SAS 3.0 specification, so aggregate throughput is limited by the single SFF8643 host link and the 12Gbps per-channel ceiling when all four drives operate simultaneously.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?