Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts one SFF8654 74pin SlimSAS port into eight SFF8482 29pin SAS connectors with four Big4Pin power leads for 100cm internal server wiring
This SMUGDESK cable splits a single SFF8654 74pin SlimSAS port into eight SFF8482 29pin SAS connectors, letting servers and storage enclosures attach multiple SAS HDDs or SSDs from one controller port. It targets administrators expanding drive counts in high-density RAID arrays, NAS appliances or data-centre mass-storage deployments.
High-grade copper conductors carry the SAS signals with minimal loss, while four integrated Big4Pin power connectors deliver electricity directly to the attached drives. The passive design adds no active components that could generate heat or noise, so thermals and acoustics remain governed by the host chassis and drive selection.
At 100 centimeters the assembly reaches between a backplane or controller card and drive bays in typical rackmount servers and storage chassis. Builders needing shorter or longer runs, or a different breakout count, must choose another cable.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Insert the SFF8654 74Pin plug into the host SlimSAS port until it clicks, connect each of the eight SFF8482 29Pin ends to the drives, then attach all four Big4Pin power connectors to the PSU; the step often missed is powering every Big4Pin so all eight drives receive stable current.
The copper wiring and connectors are passive; no scheduled maintenance is required, but inspect the 74Pin and 29Pin ends for dust or bent pins during hardware swaps and replace the assembly if any connector shows physical damage or intermittent contact.
The 100CM copper run sets the practical signal-length ceiling; beyond this distance signal integrity degrades first, so sustained maximum throughput across all eight SFF8482 29Pin links is reliable only within the supplied 100CM length.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?