Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a single 74-pin SFF-8654 8i port to eight 90-degree SATA connectors using 30 AWG copper wire over a .8 m length
This SlimSAS low-profile harness connects a single SFF-8654 8i 74-pin port to eight 90-degree SATA 7-pin connectors. The .8 m length and 30 AWG copper construction suit dense rackmount chassis and internal storage expansions. It targets administrators wiring high-density backplanes or building NAS appliances.
The cable requires a host controller or backplane presenting exactly one SFF-8654 8i 74-pin receptacle. Each of the eight breakout leads terminates in a right-angle SATA plug, so the receiving drives or backplane must accept standard 7-pin SATA data connectors. Systems lacking this specific SlimSAS port cannot use the harness.
The 90-degree SATA ends let cables run parallel to drive PCBs, reducing bend radius and freeing vertical clearance in 1U or 2U servers. The .8 m reach keeps slack minimal inside crowded enclosures, while 30 AWG conductors maintain signal integrity across all eight lanes. Buyers needing longer runs or straight SATA heads should select a different harness.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The cable itself is passive copper; real-world throughput is capped by the RAID card and the SATA drives attached, not by the harness.
The SFF-8654 8i connector carries SAS lanes; the breakout converts each lane to a native SATA 7-pin link for the drives.
The LP plug sits close to the board; allow roughly the height of the angled SATA heads plus a few millimetres for the latch.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?