SMUGDESK USB 3.0 to SATA III Adapter Cable
Connects 2.5 and 3.5 inch SATA drives to USB 3.0 for fast data transfer, cloning and recovery without an enclosure
- Up to 6Gbps transfer speed via SATA III interface
- Works with 2.5 and 3.5 inch SATA HDD or SSD drives
- Instant external storage access without a hard drive enclosure
- Plug and play operation for backup, cloning and migration
- 5 inch drives need external power for stable operation
USB 3.0 to SATA III Adapter Cable
This USB 3.0 to SATA III adapter cable connects standard SATA hard drives and SSDs to a computer without a drive enclosure. It supports both 2.5-inch laptop drives and 3.5-inch desktop HDDs. The plug-and-play design works on mainstream operating systems without driver installation. It is suited for technicians, content creators and enthusiasts needing quick drive access.
Thermals noise and power draw
The adapter itself draws minimal power from the USB port and adds no audible noise. 2.5-inch SSDs and laptop hard drives typically run from bus power alone. 3.5-inch mechanical hard drives require an extra external power supply to ensure stable operation and prevent recognition failures. No active cooling is needed for the cable.
Upgrade from drive enclosure
This cable replaces a bulky drive enclosure for bench testing, data migration and emergency file retrieval. It is ideal when you need temporary access to bare SATA drives without permanent installation. It does not suit users who want a protective case for long-term portable storage or need to connect drives without SATA interfaces.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $12.99
- Cheaper than about 55% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How do I connect a 3.5-inch SATA drive using this adapter cable?
Plug the SATA connector into the drive, insert the USB 3.0 plug into the computer, then attach the required external power supply to the 3.5-inch drive before turning it on.
Will the USB 3.0 connector or SATA plug wear out with repeated drive swaps?
The USB 3.0 and SATA interfaces are rated for thousands of insertion cycles, so normal technician or DIY use will not require replacement of the cable itself.
What limits transfer speed during a long cloning job with a SATA III SSD?
The adapter caps throughput at the SATA III 6Gbps maximum, so sustained speeds cannot exceed that ceiling even if the SSD is faster.
More in SATA & eSATA Drive Cables
Similar items
Nippon Labs SATA-0.5RR 0.5m SATA cable right-angle pair
- 1.64 ft (0.5m)
- SATA II
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
COMeap SATA power cable 6 pin to 3×15 pin 20 in 50 cm
- 6 Pin, Sata 15 Pin
- SATA





