Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 40 mm maglev case fan moving 9.5 CFM at 8,500 rpm with a 2-pin connector and 32 dBA noise
The SXDOOL 4010 measures 40 by 40 by 10 millimetres and uses a maglev motor with a two-pin power connector. It suits small-form-factor builds, server trays or tight GPU brackets where a standard 120 mm frame cannot fit. Buyers who need higher static pressure for dense radiators or larger airflow for full-tower cases should look elsewhere.
Rated at 12 volts with a 4.5 to 13.8 volt operating range, the fan draws 0.15 amps for 1.8 watts and spins at 8500 rpm. It delivers 9.5 cfm of air volume while producing 32 dBA of noise. The wide voltage window lets it run from motherboard headers or fan controllers without exceeding its power envelope.
The frame is glass-fibre reinforced plastic with a PBT shell and PA blades, meeting environmental protection certification. Maglev bearing construction removes physical contact at speed, reducing wear and keeping vibration low over time. Two-pin wiring provides power and ground only, so speed reporting or PWM control is not available.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Power | |
|---|---|
| Power input connector | 2 Pin |
| Size & build | |
| Fan size | 40 mm |
Mount the 40x40x10 mm frame with four screws, then connect the 2-pin plug to a 12 V header; the step often missed is checking that the motherboard header supplies 4.5–13.8 V so the maglev motor starts reliably.
The maglev motor has no physical contact bearings to wear out, so no routine lubrication or bearing swap is required; only clean dust from the PA blades periodically to keep the 9.5 cfm airflow at 8500 rpm.
The 1.8 W power draw at 0.15 A is the first constraint; if the 2-pin header or wiring cannot deliver steady current the fan will throttle before heat or noise (32 dBA) becomes an issue.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?