Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
80mm PWM case fan with double ball bearing rated for 50000 hours at 25°C
The SXDOOL 80 mm case fan uses a double ball bearing rated for 50000 hours at 25 C and 45 to 85 percent humidity. It draws 3.84 A at 12 V through a standard four-pin PWM connector. The 38 mm thick frame suits servers or workstations that need high-volume airflow in a compact slot. Buyers who need larger diameter fans or RGB lighting should look elsewhere.
The fan requires a motherboard header capable of supplying 3.84 A at 12 V, which exceeds many consumer four-pin headers rated around 1 A. If the header cannot deliver that current the fan may run at reduced speed or fail to start. A three-pin header will power the fan but removes PWM control so speed cannot be regulated by the board. Builders without a high-current header must use a dedicated fan controller or powered hub.
The 38 mm thickness is deeper than standard 25 mm case fans so verify clearance against side panels, cable routing and CPU cooler overhang before mounting. Four corner holes accept standard M3 screws; overtightening can crack the plastic frame. Because the bearing is not user-serviceable, any grinding noise after installation usually means the fan must be replaced rather than lubricated.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Case Fan |
| Product color | Black |
| Power | |
| Power input connector | 4 Pin |
| Size & build | |
| Fan size | 80 mm |
| More details | |
| LED lighting | Non-LED |
The fan is an 80 x 80 x 38 mm unit with a 4-pin PWM connector, rated at 12 V and 3.84 A, so it fits any standard 4-pin motherboard header.
At full PWM duty the fan draws 3.84 A from the 12 V rail, delivering the maximum airflow and pressure the double-ball bearing motor can produce.
The 4-pin PWM interface allows the motherboard to vary speed from minimum to maximum while reporting real-time RPM through the tachometer wire.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?