Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 70 mm square case fan spinning at 4900 RPM with a ball bearing, 12 V .40 A draw and 21 cm bare leads
The SXDOOL AGE07025B12H is a 12V DC axial fan with a 70x70x25mm frame and ball-bearing construction. It spins at 4900 RPM and draws 0.40A from a two-wire bare-lead harness approximately 21cm long. This single unit suits equipment-cooling assemblies that require the exact model, voltage and dimensions shown on the label.
Install this fan when the original AGE07025B12H or an identical 12V 0.40A ball-bearing unit has failed or become noisy. The jump is worth it only if the mounting holes, frame thickness, wire count and lead length match the original specification; otherwise the fan will not fit or connect. Verify every parameter on the old label before ordering.
The red and black leads carry power only, with no tachometer or PWM wire, so the motherboard or controller cannot monitor speed or adjust it automatically. Polarity is not marked on the leads, so incorrect wiring will prevent operation. The 21cm length may fall short in larger enclosures, and the lack of a standard connector means soldering or crimping is required for most PC builds.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The frame measures 70 mm by 70 mm and is 25 mm thick; match these dimensions and the hole pattern to your chassis or heatsink before fitting.
Identify the positive and negative pins on your 12 V header, strip the 21 cm leads if needed, then solder or crimp them to the correct polarity before powering on.
Ball bearings typically run for tens of thousands of hours at 4900 RPM; listen for new noise or vibration as the signal to swap it out.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?