Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Dual-rotor 40×40×48 mm 12 V PWM server fan delivers high airflow from a compact frame
The SXDOOL IFD04048B12-A01 packs two counter-rotating rotors into a single 40 by 40 by 48 millimetre frame. It is built for 1U server chassis and other tight spaces that demand concentrated airflow from a minimal footprint. The unit draws a maximum of 1.9 amperes at 12 volts, with a measured operating current of 0.8 amperes. PWM control allows the motherboard or fan controller to regulate speed precisely.
Dual rotors move a high volume of air through the rectangular housing while the PWM circuit keeps RPM proportional to thermal load. At the measured 0.8 ampere draw the fan runs cooler and quieter than its peak rating suggests. The 12 volt supply rail feeds both rotors in parallel through the integrated wiring. Acoustic output scales with the PWM duty cycle, staying restrained at low loads.
The moulded industrial plastic frame weighs 89 grams and resists vibration in dense rack mounts. A 3.5 centimetre six-pin plug terminates the parallel-wired leads, so the installer must route the cable immediately adjacent to the fan header. Red and black conductors carry positive and negative respectively. The compact connector suits server backplanes but may require an extension for standard desktop boards.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Mount the 40×40×48 mm frame with four screws, then connect the 6-pin small plug; the two rotors are already wired in parallel so only one PWM header is needed.
The industrial plastic body and dual-rotor assembly run on sealed bearings; periodic dust removal from the blades is the only upkeep required.
Measured current settles at 0.8 A under normal operation, well below the 1.9 A maximum, so the PWM controller reaches its duty-cycle ceiling before the motor hits its current limit.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?