Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
80 mm dual-ball-bearing PWM fan spinning up to 7000 RPM with 31 cm 4-pin lead
This 80mm case fan uses a double-ball bearing and a 4-pin PWM connector for motherboard speed control. It runs on 12V power with a 3A rating and reaches speeds above 7000 RPM. The black, non-LED frame measures 80 by 80 by 38mm with a 31cm lead.
Builders fitting an 80mm mount with a 4-pin header can use the wide 1000 to 8500 RPM range for targeted cooling. The 3A draw demands a header or controller rated for that current. It is not for systems limited to lower-amperage fan headers, silent-priority builds, or cases that only accept 25mm or thinner fans.
The bearing type is the key durability spec; double-ball construction targets long service life in continuous operation. PWM control allows the motherboard to adjust speed between the stated minimum and maximum. Verify that your board’s 4-pin header can supply 3A before installing.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Case Fan |
| Product color | Black |
| Performance | |
| Rotational speed | >7,000 RPM |
| Power | |
| Power input connector | 4 Pin |
| Size & build | |
| Fan size | 80 mm |
| Bearing design | 2 Ball |
| More details | |
| LED lighting | Non-LED |
Mount the 80×80×38mm frame with four screws, connect the 4-pin 2510 connector to the motherboard PWM header, and route the 31cm cable; the step most often missed is plugging into the PWM header instead of a 3-pin voltage header, which disables speed control.
The double ball bearing is rated for 180000 hours; no lubrication is required, but expect eventual bearing wear — plan to replace the entire fan once noise or vibration appears after that service interval.
At speeds above 7000 RPM up to the 8500 RPM maximum the 3A current draw becomes the limiting factor — ensure the motherboard header or fan controller can supply 12V at 3A continuously or the fan will throttle or shut down.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?