SXDOOL S124010DM VGA Cooling 12V .08A .15A 2-pin
A 12 V graphics card fan drawing 0.08 A or 0.15 A with a two-pin connector
- Runs on standard 12V graphics-card power
- Low 0.08A draw at minimum speed
- Higher 0.15A available for demanding loads
- Simple two-pin connector fits existing headers
- Direct replacement for S124010DM model
Replacement graphics-card fan
The SXDOOL S124010DM is a direct-replacement cooler for graphics cards that use a 12 V two-pin connector. It draws either .08 A or .15 A depending on speed setting, matching the electrical profile of many OEM fans. Installers can swap the unit without rewiring the card's power header.
Upgrade from noisy or failed OEM cooler
This fan replaces an original cooler that has become loud, developed bearing rattle or stopped spinning entirely. The jump is worth it when the card still performs well but thermals throttle clocks or the noise level disrupts work. No new mounting holes or voltage adapters are required for compatible models.
Steady airflow under continuous load
At 12 V the motor maintains constant rpm during extended gaming or render sessions, avoiding the speed droop seen in worn sleeves. The dual current rating lets the card's fan curve shift between quiet idle and higher airflow without stalling. Heat dissipation stays predictable over hours of sustained load.
How it compares
Measured against everything we stock in GPU Fans & Heatsinks, at today’s prices. Recalculated every night.
- Price $14.99
- Cheaper than about 80% of the 143 comparable items (median $19.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What connector does the SXDOOL S124010DM fan use to plug into the graphics card?
It uses a 2-pin plug that carries 12V power at either .08A or .15A depending on the speed setting.
How do I install this fan on my video card, and what step is often missed?
Remove the old cooler, align the screw holes on the S124010DM housing, secure it, then connect the 2-pin plug to the board header — the step many miss is routing the cable so it cannot foul the spinning blades.
What part of this fan will need replacement first and how can I tell?
The sleeve bearing inside the motor wears over time; when you hear a new rattle or the RPM drops below spec at 12V, the fan itself should be swapped.
More in GPU Fans & Heatsinks
Similar items
Thermaltake CL-W183-CU00TR-A Pacific V-GTX 1080Ti Founders Edition Transparent vga cooling
- NIVDIA Geforce GTX…
- Dimension: 22.6 × 1…
SXDOOL 2pcs 95mm FDC10U12S9-C CF1010U12S VGA Cooling Fan for Radeon RX580 RX590
- Case Fan Accessory
Thermaltake CL-W184-CU00TR-A Pacific V-GTX 1080Ti Transparent ASUS ROG vga cooling
- ASUS ROG STRIX GTX1…
- Dimension: 19.4 × 1…





