Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
12 ft 14 AWG SAE to alligator-clip adapter with built-in 20 A fuse and weatherproof covers
This 12 ft extension cable uses 14 AWG conductors with a cross-section of 2.08 mm2, which is larger than 16 AWG at 1.31 mm2. It connects a standard SAE quick-release plug to alligator clips for 12 V battery charging or maintenance. A 20 A fuse is installed in the holder, and both 20 A and 25 A spare fuses are included. The assembly is supplied new with a 12-month manufacturer warranty.
The SAE connector is a widely used two-pin standard for lead-acid and lithium battery tenders, but it is rated for low-voltage direct current only. The built-in 20 A fuse sets the maximum continuous current the cable can carry before opening, so loads above that level will interrupt the circuit. Both the SAE plug and the fuse holder feature weatherproof covers to resist moisture during outdoor use. No higher-voltage or alternating-current application is supported by this adapter.
Verify that the SAE polarity on your charger matches the alligator clip markings, because SAE connectors are not keyed and reverse connection can damage equipment. Ensure the 20 A fuse rating suits the charger output; if the charger can exceed 20 A, the fuse will blow and the spare 25 A fuse does not raise the cable's safe limit. Confirm the 12 ft length reaches your battery location without strain, and inspect the weatherproof covers for damage before each use.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Use the 20A fuse for standard 12V charging circuits; fit the 25A spare only if your charger manual specifies a higher rating and the 14AWG conductors can handle the load.
The 2.08 mm² copper cross-section supports the fitted 20A fuse continuously, with lower voltage drop than thinner 16AWG wire over the 3.66 m length.
Yes, it uses the industry-standard SAE two-pin quick-release plug found on most 12V battery chargers and maintainers.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?