Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 2 ft heavy-duty adapter connects a NEMA 6-20 plug to a 6-20R or 6-15R receptacle using 12 AWG copper wire rated for 20 A, 250 V and 5000 W
This power adapter connects a NEMA 6-20 plug to a NEMA 6-20 receptacle that also accepts a 6-15 plug. It is built for equipment requiring a 250-volt, 20-amp supply up to 5000 watts. The 12 AWG copper conductors handle the rated load without overheating. The two-foot length suits rack or bench setups where a short reach is needed.
Plug the male end into the supply outlet and insert the device plug into the female receptacle; the T-blade slot accepts both 6-20 and 6-15 plugs. Ensure the outlet circuit is rated for 20 amps and that the plug seats fully to avoid arcing. A loose connection or an undersized breaker will cause nuisance trips or heat buildup. Do not coil the cord tightly while under load.
The adapter passes 250 volts at up to 20 amps, so any device drawing more than 5000 watts will exceed the rating. The 12 AWG cable is not rated for continuous loads above 20 amps, and voltage drop becomes noticeable on longer runs beyond this short length. It provides no ground-fault or over-current protection; the supply circuit must supply those safeguards. The receptacle is limited to NEMA 6-20 and 6-15 blade configurations only.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The adapter uses 12 AWG 100% copper conductors rated for 20A continuous loading. If your connected equipment runs without tripping its breaker or overheating the cord, the adapter is performing to its 5000W specification.
The package contains the 2-foot adapter cord with a NEMA 6-20P male plug on one end and a 6-20R/6-15R T-blade female receptacle on the other. No additional cords or connectors are required for standard 6-20 or 6-15 equipment.
This 69571 model is built with 12 AWG copper wire rated for 20A, 250V and 5000W, matching a 20A 250V tool exactly. Select it when your device uses a 6-20P or 6-15P plug and you need a 2-foot reach.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?