Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Five brass MK10 nozzles with 0.2 mm bore for 1.75 mm filament, stamped for easy identification
This pack contains five brass nozzles designed for MK10 hot-ends that accept 1.75 mm filament. Each nozzle has a 0.2 mm orifice and an M7 thread with a 4 mm thread length. The set is intended for owners of compatible 3D printers who need replacement or spare nozzles.
Brass construction resists rust and erosion during normal printing with non-abrasive materials such as PLA or ABS. The supplier notes typical hot-end temperatures of 180 to 220 for PLA and 240 to 280 for ABS. No active cooling or power-draw figures are provided for the nozzles themselves.
The package includes only the five nozzles; no tools or lubricants are bundled. The supplier recommends holding the heat block with a spanner while fitting the new nozzle and recalibrating the nozzle-to-bed distance after replacement. A stamp on each nozzle identifies the bore size for quick selection.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
Heat the hotend to 180-220°C for PLA or 240-280°C for ABS, hold the heat block with a spanner, then unscrew the old nozzle and screw in the new one until tight; recalibrate the nozzle-to-bed distance afterwards.
Brass wears faster with abrasive filaments; for non-abrasive PLA, ABS or PCL the 5-pack gives spares, so swap a nozzle when the 0.2mm orifice shows visible rounding or extrusion becomes inconsistent.
The small 0.2mm diameter restricts volumetric flow, so sustained high-speed printing will cause under-extrusion or pressure buildup before the brass material itself reaches a thermal limit.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?