Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of 10 NTC 3950 100K Ohm thermistors accurate to ±1% from -40 °C to 250 °C for 3D printer hot ends and heated beds
This pack contains ten NTC 3950 thermistors rated at 100K Ohm with ±1% accuracy. They operate across a -40 °C to +250 °C range for precise temperature monitoring. Each sensor fits heating blocks designed for thermocouple-style probes. The components are new and ready for installation.
These thermistors suit owners of RepRap, Ender 3, Ender 3 Pro, Ender 5, CR-10 or CR-10S machines needing replacement or spare hot-end and heated-bed sensors. Builders using printers that require a different resistance value, connector type or probe geometry should look at other parts. The ten-piece quantity also exceeds the needs of a single repair.
The 100K Ohm nominal resistance at 25 °C is the critical parameter that must match the printer firmware configuration. If the control board expects a different resistance curve the temperature readings will be incorrect and prints will fail. Verify this value against your firmware settings before purchase.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
At 250 °C the resistance drops far below 100K Ohm, letting the printer firmware calculate the exact temperature from the 3950 Beta curve.
The leads are bare wires; they are inserted directly into the two-pin thermistor header on boards used by Ender 3, Ender 5, CR-10 and similar printers.
The glass bead is a standard 3 mm cartridge that slides into the 3 mm thermistor bore found on most RepRap-style heater blocks.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?