Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Set of 30 carbon-steel compression springs, 7.5 mm outer diameter and 20 mm free height, for levelling 3D printer heated beds
This pack contains thirty compression springs sized for 3D printer heated beds. Each spring is made from carbon steel for higher fatigue resistance and surface hardness than ordinary steel. The dimensions are 7.5 mm outer diameter, 5 mm inner diameter, 1.2 mm wire diameter and 20 mm free height. They suit most common printer beds that accept this spring size.
The supplier notes that the springs perform best on aluminium bed plates of 3.5 mm thickness or greater. Thinner plates may not provide enough rigidity for consistent bed levelling. Using the recommended plate thickness helps the springs maintain even pressure across the build surface during heating and printing cycles.
The critical specification is the 7.5 mm outer diameter, which must match the mounting holes or slots on your printer’s bed carriage. If your machine uses a different spring diameter these will not install correctly. Verify the required outer diameter before ordering to avoid compatibility issues.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
Inspect the 30 springs each time you relevel the bed; replace any that have lost free height or show permanent compression.
The 5 mm inner diameter and 1.2 mm wire set the maximum plate thickness at roughly 3.5 mm aluminium or equivalent.
The carbon-steel springs are passive components; they generate no heat, noise or vibration during all-day printing.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?