Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Set of five brass MK8 nozzles in 0.2, 0.3, 0.4 and 0.5 mm diameters for 1.75 mm filament
This five-piece brass kit supplies 0.2 mm, 0.3 mm, 0.4 mm and 0.5 mm nozzles with M6 threads for MK8 hot-ends. It targets hobbyists and small-shop operators who print PLA, ABS or PCL on 1.75 mm machines such as Creality CR-10 or Prusa i3 variants. The assortment lets users swap orifice size to match layer-height or speed requirements without sourcing separate parts.
Only hot-ends that accept an M6 thread with a 5 mm thread length and a 2 mm input bore can use these nozzles. Printers built for 3 mm filament or proprietary thread standards will not fit. The brass material handles non-abrasive polymers but wears quickly with carbon-fibre or glow-filled grades, so those filaments are outside the intended use.
Heat the block to the filament temperature, hold the heater block with a spanner and unscrew the old nozzle with a socket driver. Screw the new nozzle in by hand then tighten lightly while the block is still warm. The supplier notes that the nozzle-to-bed gap must be recalibrated after every change; skipping this step is the most common cause of first-layer adhesion failure.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
The 0.4mm nozzles are the standard choice for general printing; use 0.2mm or 0.3mm for finer detail and 0.5mm for faster, stronger layers.
These nozzles accept 1.75mm filament directly through the 2mm input bore, matching the filament size used by most Creality CR-10, Makerbot and Prusa i3 machines.
The M6 thread with a 5mm length screws straight into standard MK8 heater blocks, so you only need a spanner and socket screwdriver to swap nozzles.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?