Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Brass extruder gear with 40 teeth and 5 mm bore grips 1.75 mm filament for 3D printers, supplied as a pair
This brass drive gear fits 3D printers that use 1.75 mm filament. The 40-tooth profile with deep grooves provides a secure grip on the material. It mounts on a 5 mm bore shaft and is secured with an M3 thread. The pack contains two identical gears for replacement or dual-drive setups.
Brass material reduces friction against the filament during normal extrusion. The 11 mm outer diameter and 11 mm height keep the gear compact inside the extruder assembly. No active cooling or lubrication is required for typical printing sessions. The gear runs quietly because there are no bearings or moving surfaces beyond the filament contact.
Under sustained load the deep grooves maintain traction without slipping on 1.75 mm filament. Brass resists wear from continuous rotation better than softer plastics. The fixed 40-tooth geometry delivers steady feed rates for extended print jobs. Heat from the hot end does not deform the gear during prolonged use.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
Slide the gear onto the 5 mm shaft, align one of the M3 set-screw holes with the shaft flat, and tighten the grub screw firmly so the 40 teeth mesh without wobble.
Periodically brush filament dust from the deep grooves and check the M3 set screw for loosening; brass wears slowly but replace the gear if the 1.75 mm filament starts to slip.
Heat creep into the brass body can soften the filament grip during long prints, causing the 40 teeth to lose traction before the motor overheats.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?