Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Stainless-steel drive gear with 40 teeth and a 5 mm bore grips 1.75 mm filament for MK7 and MK8 3D printers
This pair of 40-tooth stainless-steel gears fits MK7 and MK8 extruders and accepts 1.75 mm filament. Each gear has a 5 mm bore, 12 mm outer diameter and 12 mm height with an M3 thread for the set screw. The deep grooves provide a secure grip on the filament during printing. Supplied as a two-piece set for direct replacement or spare-part stock.
Swapping to these steel gears is worthwhile when the original drive gear shows stripped teeth, rounded grooves or inconsistent extrusion. The harder material resists wear from abrasive filaments and maintains tooth profile longer than standard plastic gears. The upgrade makes sense for printers running high-volume jobs or filled materials that accelerate gear degradation.
Installation requires a stepper motor with a 5 mm shaft and an M3 set screw to lock the gear in place. The 12 mm diameter keeps the gear compact inside typical extruder bodies, leaving room for the idler bearing and tension spring. No additional spacers or adapters are needed when the printer already uses MK7 or MK8 hardware.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
The gear has a 12 mm outer diameter and a 5 mm bore, matching the standard MK7/MK8 extruder shaft size.
Slide the gear onto the 5 mm shaft, align the M3 grub screw with the flat on the motor shaft, and tighten gently — over-torquing the small M3 thread is the common mistake.
Replace them when the deep grooves that grip 1.75 mm filament show visible wear or the teeth no longer advance filament reliably.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?