Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
PTFE bowden tubing with a 2 mm bore guides 1.75 mm filament through 3.2 ft of low-friction red PTFE
This PTFE tube is a replacement Bowden guide for 3D printers that run 1.75 mm filament. The 2 mm inner diameter gives the filament a precise, low-friction path from extruder to hot-end. It suits owners of Anet, RepRap, Prusa or MendelMax machines and most other printers using the same bore size. The red colour makes the tube easy to spot during maintenance.
Makers who need a 3.2 ft length of 2 mm ID tubing will find this a direct fit. The PTFE material resists heat and chemical wear in typical printing environments. Printers that use 1.75 mm filament with a standard 4 mm push-fit coupling are the intended users. Builders whose extruders demand a different inner diameter or a longer continuous run should look elsewhere.
The single specification that determines compatibility is the 2 mm inner diameter matched to 1.75 mm filament. If your hot-end or coupler requires a larger or smaller bore, this tube will not seal correctly. The 4 mm outer diameter and 3.28 ft length are secondary; the ID is the critical measure.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Unique Bargains |
The 2 mm bore leaves a small clearance around 1.75 mm filament, letting it feed smoothly without binding in most Bowden setups.
A 4 mm OD fits standard 4 mm push-to-connect fittings and keeps the tube narrow enough for tight cable chains on common printers.
At 3.28 ft the tube covers typical Bowden runs; measure your own path and trim the PTFE to the exact length you need.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?