UXCell 18‑Pipe Water Cooling Radiator 270mm Black
An aluminium water-cooling radiator with 18 tubes and G1/4 fittings for custom liquid loops
- Accessory categoryCooler
- 18 pipes spread heat across a 270 mm aluminium core
- G1/4 fittings accept 8–12 mm inner-diameter tubing
- Black oxidation finish raises thermal efficiency
- 105 mm square mounting pattern fits standard brackets
- Includes short and long screws for flexible installation
18‑Pipe Aluminium Radiator for Custom Loops
This 270 mm long black aluminium radiator provides eighteen internal channels for liquid flow. It accepts tubing with an inner diameter of 8 to 12 mm and an outer diameter of 11 mm via standard G1/4 inch threads. The unit suits builders assembling a custom water‑cooling circuit for a CPU or industrial heat source.
Upgrade from Stock Air or Single‑Row Radiators
Replacing a basic air cooler or a thinner single‑row radiator with this 30 mm thick core adds significant surface area for heat exchange. The jump is worthwhile when the existing loop cannot shed enough heat under continuous load and the case can accommodate the 270 x 120 mm footprint with 105 mm mounting centres.
Steady‑State Heat Dissipation
Under sustained load the aluminium fins and eighteen tubes spread thermal energy across the full 270 mm length, allowing the liquid temperature to stabilise rather than climb rapidly. The black oxidation finish aids emissivity during prolonged operation. No fans, pump or fittings are included, so sustained performance depends on the airflow and flow‑rate the builder supplies.
How it compares
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
- Price $29.99
- Pricier than about 70% of the 6,169 comparable items (median $20.99).
Specifications
| Product | |
|---|---|
| Accessory category | Cooler |
Questions about this item
What case clearance does the 270 mm long radiator with 105 mm mounting holes need?
The radiator measures 270 mm long, 120 mm wide and 30 mm thick. Mounting holes are spaced 105 mm apart, so allow at least that much clear space.
How do I install the G1/4 inch fittings without stripping the threads?
Hand-tighten each G1/4 fitting until the O-ring seats, then give a quarter turn with a spanner. Over-tightening the soft aluminium threads is the common mistake.
When should I replace the coolant in this 18-pipe aluminium radiator?
Drain and refill the loop every 12–18 months, or sooner if the fluid darkens or particles appear. Aluminium channels can corrode if old coolant is left too long.
More in Laptop Cooling Stands & Fans
Similar items
DELL MGK85 laptop lid cover 17" blue for Inspiron 17R N7110
- Skin / Cover
- SWITCH by Design St…
LUOM C08LS-Silver Aluminium Laptop Stand 10-15.6
- Stand
- Support up to 15.6-…
LUOM X6CS laptop cooling pad silver 4 fans 13.3
- Stand
- 13.3 in (33.8 cm)





