Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of two 1.64 ft Mini SAS 36-pin SFF-8087 male to four SATA female breakout cables for connecting a RAID controller to up to eight SATA drives
This cable connects a RAID or PCIe controller with an SFF-8087 port to four SATA drives. It is built for system builders expanding internal storage using hardware RAID arrays. Two cables in the pack support up to eight drives across two controller lanes. It suits servers and workstations that use multi-lane SAS host bus adapters.
The flat ribbon construction reduces airflow obstruction inside the chassis. Woven mesh sheathing covers half the length for protection without adding stiffness. Acetate cloth tape at the fan-out provides strain relief at the connector junctions. No active components or external power are required for operation.
Each 0.5 metre cable reaches from a controller card to a backplane or drive cage in typical chassis layouts. Two cables enable an eight-drive array using a single dual-port adapter. The forward fan-out orientation simplifies routing to stacked drive bays. Buyers needing longer runs or right-angle connectors should verify case clearance before ordering.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Cable Connectors |
| Product color | Black & Blue |
| Ports & slots | |
| Connector count | 5 |
| Connector details | 1 x SAS to 4 x SATA |
| Connector gender | Male to Female |
| Size & build | |
| Overall length | 1.64 ft (0.5 m) |
Plug the 36-pin SFF-8087 male connector firmly into the controller port; the four SATA female ends attach to the backplane or drives. Route the 1.64 ft ribbon carefully to avoid sharp bends.
The tape and woven mesh are passive strain relief; they do not wear out in normal operation. Replace the cable only if connectors loosen or the ribbon shows physical damage.
Each drive is limited to 6 Gb/s by the SAS-to-SATA breakout; the host link uses PCIe 2.0 x8 lanes, so the per-drive 6 Gb/s cap is reached before the host bandwidth saturates.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?