Vszerda 12VHPWR ATX 3.0 PCI-E 5.0 16AWG 17cm 90° down angled extension internal power cable
A 17 cm 12VHPWR ATX 3.0 PCI-E 5.0 extension with a 90° down angle delivers up to 600 W to RTX 3080 or 3090 Ti graphics cards
- ATX 3.0 and PCI-E 5.0 ready for modern GPUs
- 90° down angle eases routing in tight cases
- 17 cm length keeps cable runs short and tidy
- 16 AWG conductors support up to 600 W delivery
- 12+4 pin 12VHPWR connector matches RTX 40 and RDNA 3 cards
12VHPWR 16AWG 90° down-angled extension cable
This 17 cm internal power cable carries a male-to-female 12VHPWR connector built to the ATX 3.0 and PCI-E 5.0 specification. It is designed for builders fitting RTX 40-series or AMD RDNA 3 graphics cards that require the 12+4 pin power interface.
Replaces a straight 12VHPWR lead when clearance is
The 90° down-angled plug routes the cable parallel to the card, freeing space behind the GPU where a straight connector would press against the side panel. The upgrade is worth it when the case window or a rear fan leaves less room than the connector height.
Check GPU power-port orientation
Verify that the card’s 12VHPWR socket faces the motherboard so the down angle points toward the case floor. Confirm the power supply provides a native 12VHPWR header; this cable extends that header and does not adapt from older 8-pin PCIe plugs.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $23.99
- Pricier than about 66% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Will the 90° down-angled 12VHPWR plug clear a 17 cm gap behind my RTX 3090?
The extension measures 17 cm end-to-end and the 90° down angle points the cable toward the motherboard, so it fits in tight rear clearances where a straight plug would hit the side panel.
Do I need to remove the GPU to connect the male 12VHPWR end to the PSU and the female end to the card?
No — route the male end into the PSU 12VHPWR port first, then plug the female end into the graphics-card socket; the short 17 cm length leaves little slack, so seat both connectors fully before securing the GPU.
When should I replace this 16 AWG 12VHPWR extension if I run an RTX 40-series card at 600 W?
Inspect the 12 power pins and 4 signal pins every 6–12 months; replace the cable if any pin shows discoloration, melted plastic or loose retention, as 600 W loads accelerate contact wear.
More in Internal PSU & Riser Cables
Similar items
Lian Li LAN2-1X PCIe 3.0 Riser Cable 200mm Vertical GPU Bracket
- Black
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





