Vszerda 18AWG PSU Extension Cable Kit Grey 24P ATX EPS 8P PCI-E 8P 300mm
An 18AWG sleeved extension kit with 24-pin ATX, 4+4-pin EPS and two 8-pin PCI-E cables at 300 mm, pre-bent for neat 180° routing and supplied with combs
- 18 AWG wire handles high current with lower resistance
- 300 mm length reaches full-tower motherboards and GPUs
- Pre-bent 180° design keeps cables flat after routing
- Male 5557 to female 5559 connectors fit standard PSU sockets
- Two combs per cable lock wires into clean parallel runs
Cable Kit Contents
The Vszerda kit supplies one 24-pin ATX extension, one 4+4-pin EPS extension and two 8-pin PCIe extensions, each 300 mm long with 18 AWG conductors inside a 3 mm sleeved jacket. Grey connectors and included combs give a uniform look for builders who want tidy cable runs without custom sleeving work.
Upgrade Path
These extensions replace the stock cables that ship with most power supplies, adding length and a pre-bent profile that keeps a neat 180-degree bend. The jump is worth it when the standard cables are too short or too flexible to hold a clean route behind the motherboard tray.
Installation Notes
Each cable arrives pre-assembled with male 5557 to female 5559 ends and two combs per cable for alignment. Do not disassemble the connectors; if length adjustment is needed, use proper crimping tools and avoid excessive force to prevent pin damage.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $23.99
- Pricier than about 66% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Will the 300 mm length and 3 mm diameter cables fit behind my motherboard tray?
Each cable is 300 ± 10 mm long and 3 mm thick, so measure your case’s cable-routing channel depth and width to confirm clearance.
How do I attach the 5557 male to 5559 female connectors without bending pins?
Align the keyed 5557 male plug with the 5559 female socket, press straight in until the latch clicks, then snap the two included combs onto each cable to lock spacing.
When should I replace the 18 AWG sleeved extensions?
Inspect the 18 AWG wires and heat-shrink-less sleeves whenever you rebuild; swap any cable that shows melted insulation, cracked sleeves or loose 5557/5559 terminals.
More in Internal PSU & Riser Cables
Similar items
Lian Li LAN2-1X PCIe 3.0 Riser Cable 200mm Vertical GPU Bracket
- Black
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
SXDOOL 6-Way PWM Fan Hub Splitter 40cm Braided internal power cable
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





