Vszerda 3-pin 1-to-2 fan splitter sleeved cable 10 inches
Connects two 3-pin fans to one motherboard header with a 10-inch sleeved cable, running both at full speed without PWM control
- Connect two fans to one header with a single 1-to-2 splitter
- 10-inch length gives flexible routing inside the case
- Black net-jacket sleeving protects wires and looks tidy
- Fans run at full speed for maximum airflow
- No PWM support so speed control is not available
What this cable does
This Vszerda splitter connects two 3-pin case fans to a single motherboard header or power-supply connector. It is intended for builders who want to add an extra fan without using another header.
Critical specification
The cable carries only 3-pin power and tachometer signals, so the fans run at full speed and PWM control is not supported. Buyers who need variable speed control via a 4-pin header cannot use this part.
Behaviour under load
Both fans receive the same voltage continuously, so they spin at constant maximum RPM for as long as the system is powered. The 10-inch sleeved length keeps the wiring tidy during sustained operation.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $14.99
- Typical for this category: the median of 7,693 items is $14.99.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What happens to fan speed when two 3-pin fans are connected through this splitter?
Both fans receive the same voltage from the motherboard header, so they run at full speed continuously without any PWM-based speed control.
How does the 3-pin interface limit control compared to a 4-pin PWM header?
The 3-pin connection carries only power, ground and a tachometer signal, so the motherboard cannot send PWM duty-cycle commands; fan speed is fixed at the header voltage.
What clearance is required to route the 10-inch sleeved cable inside a case?
The black net-jacketed cable measures 10 inches from the motherboard header to the Y-split, so allow at least that much free path between the header and the two fan mounting points.
More in Internal PSU & Riser Cables
Similar items
Silverstone CPF01 1-to-2 PWM Fan Splitter Cable 3.94 in
- 3.94 in (10 cm)
- Fan Power Cables
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
STARTECH ATXP4EXT 8in ATX12V 4 Pin P4 CPU Power Extension Cable
- 0.5 ft (0.15 m)
- Cable Connectors
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





