Rocstorage, Inc Y10A101-W1 DisplayPort to HDMI adapter
- Consumer Electronics
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a 4.5 x 3.0 mm bent male plug to a 5.5 x 2.1 mm female jack in a 10 cm cable
This adapter converts a 4.5 x 3.0 mm bent male barrel plug to a 5.5 x 2.1 mm female barrel jack. It enables power compatibility between laptop supplies and devices using the larger connector standard. The short 10 cm cable keeps the link tidy on a desk or in a bag. Builders needing a different tip size or a longer reach cannot use this unit.
As a passive cable assembly, the adapter generates no heat and produces zero acoustic noise during normal operation. Power draw is limited to the connected supply and load with no active circuitry added. The compact moulded housings add negligible bulk to the charging setup.
Under continuous use the copper conductors maintain steady conductivity without active cooling requirements. Voltage drop remains proportional to the total circuit length and the supply's own regulation. The fixed 10 cm length prevents excess resistance that longer cables would introduce.
Measured against everything we stock in Jumper & Adapter Power Cords, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Align the bent male connector with the laptop's 4.5 x 3.0mm DC input and push straight in until fully seated; the right-angle shape reduces strain on the port.
The female jack is rated for standard mating cycles; avoid side loads on the 10cm cable to prevent premature loosening of the centre pin contact.
The short 10cm length minimises resistance, but the 5.5 x 2.1mm interface typically supports up to 5 A; sustained loads near that limit will cause measurable voltage drop.
More in Jumper & Adapter Power Cords
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?