Rocstorage, Inc Y10A101-W1 DisplayPort to HDMI adapter
- Consumer Electronics
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a 4.8 x 1.7 mm power plug to a 5.5 x 2.1 mm jack in a 10 cm cord
This adapter converts a 4.8 x 1.7mm male barrel plug to a 5.5 x 2.1mm female jack. It allows a charger with the smaller tip to power a laptop requiring the larger barrel size. The cord measures 10cm end to end. It is built for portable use between compatible devices.
The short cable run keeps resistance low during sustained charging sessions. Solid brass contacts maintain a firm grip inside both barrel sizes without loosening from vibration. The moulded strain relief protects the solder joints where the wire meets each connector. No active components mean nothing to overheat or throttle over time.
The adapter passes centre-positive polarity straight through without alteration. It only bridges the two stated diameters — 4.8mm to 5.5mm outer and 1.7mm to 2.1mm inner. Devices using centre-negative wiring, locking collars, or non-standard pin depths will not mate correctly. Voltage and current remain governed by the source charger and laptop requirements.
Measured against everything we stock in Jumper & Adapter Power Cords, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The short 10 cm length keeps resistance minimal, so the adapter does not generate measurable heat or power loss during continuous operation.
Your laptop needs a 4.8 x 1.7 mm DC input jack and your power supply must terminate in a 5.5 x 2.1 mm male plug for the adapter to connect both sides.
Yes, any legacy charger with a 5.5 x 2.1 mm male connector will mate with the female side, letting you power a 4.8 x 1.7 mm laptop port.
More in Jumper & Adapter Power Cords
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?