Vszerda 4-Pin PWM Fan Hub Splitter Cable 1 to 5 Way 13 inch
A 13-inch braided cable splits one motherboard header into five PWM or three-pin fan connections for cleaner case wiring
- Connect up to five fans from one motherboard header
- Works with both 4-pin PWM and 3-pin fan connectors
- 13 inch braided nylon sleeving keeps the build tidy
- Simple plug-and-play installation with no software required
- Extends reach between motherboard and CPU or case fans
Five-Fan PWM Hub for ATX Builds
This splitter cable turns a single motherboard 4-pin PWM header into five fan connections. It suits builders who want to run multiple case or CPU fans from one control point without adding a powered controller. The hub accepts both 4-pin PWM and 3-pin voltage-controlled fans.
Braided 13-Inch Leads Keep Routing Clean
Each lead uses black nylon-braided sleeving that resists kinking and looks tidy behind a motherboard tray. The 13 inch length reaches most ATX fan mounts while avoiding excess slack. Plug-and-play design means no drivers or BIOS setup are required.
Replaces Daisy-Chain Adapters and Short Splitters
Builders moving from a basic two-way splitter gain three extra ports and longer, managed cables. The upgrade is worth it when fan headers are scarce and you need independent speed reporting from the primary PWM fan. Not suited for systems that require powered hubs for high-current fans or more than five connections.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $9.99
- Cheaper than about 80% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Does the 4-pin PWM header pass speed control to all five fan ports?
Yes, the single 4-pin PWM input drives speed signals to every connected 4-pin or 3-pin fan on the hub.
How much clearance does the 13 inch sleeved cable need behind the motherboard tray?
The braided nylon sleeve adds minimal bulk; allow a few millimetres for the connector heads and the cable bend radius.
Which connector must go to the motherboard for PWM to work?
Plug the lone 4-pin male end into the CPU or chassis fan header; the five 4-pin female ports then receive the control signal.
More in Internal PSU & Riser Cables
Similar items
Ruth's sister 25mm Large Diaphragm Cartridge Core Capsule internal power cable
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Ruth's sister USB-C Female to 4.0x1.7mm DC Adapter for Lenovo IdeaPad 310 110 100 internal power cable
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





