Vszerda 8-Way Fan Hub 12V/7V Molex Powered internal power cable
Connects up to eight 3-pin or 4-pin fans to a single Molex header with a three-position switch for high, low or off speeds
- Expands one Molex header to eight fans
- Three-level speed switch sets 12 V, 7 V or off
- Powers 3-pin and 4-pin fans from PSU
- Compact 53 × 48 mm board fits tight spaces
- Adhesive backing secures hub inside the chassis
8-way fan hub for Molex-powered builds
This hub expands a single Molex 4-pin connector into eight 3-pin or 4-pin fan headers. It is built for enthusiasts who need to run multiple chassis fans from one power source. The compact PCB measures 53 by 48 millimetres and includes adhesive backing for secure mounting inside the case.
Manual three-level speed control under load
A physical switch on the hub selects high speed at 12V, low speed at 7V, or off for complete shutdown. Because power comes directly from the PSU Molex line, all connected fans maintain their chosen speed without drawing current from the motherboard header. The design supports simultaneous start-up across every channel.
Molex-powered splitter with eight 3-pin outputs
The decisive specification is the single Molex 4-pin input driving eight fan ports with three-position manual voltage selection. Builders who need PWM signalling from the motherboard or software-based fan curves should look elsewhere, as this hub provides only fixed 12V, 7V or off settings.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $14.99
- Typical for this category: the median of 7,693 items is $14.99.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How much heat or noise does the hub itself add when eight fans run continuously on the 12 V setting?
The hub is a passive splitter with no active cooling or electronics that generate measurable heat or noise; all power passes straight from the Molex connector to the fans.
What power connector must the power supply provide for this hub to operate?
A standard Molex 4-pin LP4 connector from the power supply is required; the hub does not draw power from the motherboard.
Will 4-pin PWM fans plugged into the hub still report speed to the motherboard?
Only the first fan header passes the tachometer signal to the motherboard; the remaining seven headers provide power and ground only.
More in Internal PSU & Riser Cables
Similar items
Silverstone CPF01 1-to-2 PWM Fan Splitter Cable 3.94 in
- 3.94 in (10 cm)
- Fan Power Cables
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
STARTECH ATXP4EXT 8in ATX12V 4 Pin P4 CPU Power Extension Cable
- 0.5 ft (0.15 m)
- Cable Connectors
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





