Vszerda ATX 24-pin 1-to-2 Y splitter cable 23.5cm
Splits one ATX 24-pin connector into two for dual PSU setups, 23.5 cm long
- Splits one ATX 24-pin into two connectors
- 20+4 pin layout fits standard ATX motherboards
- 5 cm length keeps cable runs tidy
- Pre-shipment tested for reliable power delivery
- Replace damaged cables without soldering skills
ATX 24-pin dual PSU splitter
This 23.5 cm Y cable splits a single ATX 24-pin (20+4) connector into two female ports so two power supplies can drive one motherboard. It is built for builders running dual-PSU configurations in workstations, mining rigs or benchmark setups. The cable ships new and tested.
Replacing a single-PSU 24-pin link
The splitter replaces a standard 24-pin ATX cable when the system load exceeds what one unit can deliver cleanly. The jump is worth it when GPU or compute density pushes peak draw past the first PSU’s rating and a second supply is already available. No adapter is needed beyond this Y cable.
Fits dual-PSU ATX builds
Both PSU 24-pin outputs plug into the male ends while the single female end connects to the motherboard. The 23.5 cm length keeps routing tidy inside mid-tower and larger chassis. Installation requires the system to be powered off and demands careful pin alignment to avoid short circuits.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $21.99
- Pricier than about 63% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What clearance does the 23.5 cm Y splitter need inside the case?
The cable is 23.5 cm long and carries a 24-pin ATX connector, so allow enough room behind the motherboard tray for that length plus the connector depth.
How do I install the 24-pin 1-to-2 splitter without damaging the pins?
Power the system off, align the 24-pin (20+4) male end with the PSU socket and each female end with the motherboard and secondary board, then press straight in until fully seated.
When should I replace this ATX 24-pin Y splitter cable?
Replace it if the insulation cracks, pins bend or discolour, or the latch no longer holds the connector firmly in the socket.
More in Internal PSU & Riser Cables
Similar items
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





