Tripp Lite U022-015 USB 2.0 A to B cable 15 ft
- USB A to USB B
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a motherboard 9/10-pin header to an external USB 2.0 port at 480 Mbps with a 20 cm nylon-braided cable
The Vszerda CY-U2-076 converts an internal 9/10-pin USB 2.0 header into a standard external USB 2.0 Type-A port. It is intended for PC builders who need front-panel or bracket-mounted USB access without occupying a rear I/O slot. The 20 cm length suits tight routing behind a motherboard tray or inside a compact chassis.
The cable carries USB 2.0 signalling at 480 megabits per second and supplies up to 5 volts at 2 amperes from the header. No active electronics are present, so thermals and noise are not applicable; power draw matches the attached peripheral up to the header rating. The short run keeps voltage drop minimal for compliant devices.
A nylon braided jacket resists tangling and abrasion during assembly and later service. The 9/10-pin plug fits the common keyed header found on most desktop boards, while the Type-A end accepts any USB 2.0 peripheral. Builders who require longer reach or internal device mounting instead of an external port should choose a different cable.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Chenyang |
| Model name | CY-U2-076 |
| Product type | USB 2.0 |
| Performance | |
| Rated speed | 480 Mbit/s |
| Ports & slots | |
| Connection type | Usb 2.0 |
| Connector details | Usb 2.0 |
| Size & build | |
| Cable length | 0.2 |
Align the missing-pin key on the 9/10Pin connector with the blocked hole on the motherboard USB header, press straight down until the shroud seats fully, then secure the external USB 2.0 Type-A port to a chassis slot.
The nylon braid is rated for long-term durability and the 9/10Pin header uses standard gold-plated pins; no scheduled replacement is required unless physical damage occurs.
The 20 cm cable meets USB 2.0 signal-integrity specs at 480 Mbps, and the 5 V 2 A ceiling is reached only when a connected device draws more than 2 A continuously.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?