Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
An 80 mm dual ball-bearing case fan running on 12 V DC with a three-wire interface
The Vszerda EFC-08E12D-EF05 is an 80 mm square fan with a 25 mm thickness that fits small-form-factor chassis and tight clearance zones. It runs on DC 12 V and draws 0.40 A through a three-wire interface, so speed reporting is available without PWM control. Dual ball bearings support continuous operation in always-on systems. This new unit suits integrators who need a direct replacement for an 80 mm mount.
Builders working with mini-ITX cases, 1U servers or older enclosures that only accept 80 mm fans will find the mounting holes line up exactly. The three-wire connector reports RPM but does not accept a PWM signal, so boards that require four-pin control cannot regulate speed automatically. Buyers who need higher static pressure for dense radiators or who want motherboard-controlled fan curves should look at something else.
The connector carries power, ground and a tachometer lead only; there is no fourth wire for PWM duty-cycle input. If your header or controller expects a four-pin fan to vary speed automatically, this fan will run at full voltage constantly. Check the header specification before ordering.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
At 12 V and 0.40 A the fan draws about 5 W, so its own heat contribution stays small during all-day operation.
A standard 3-pin 12 V fan header is required; the fan will run at full speed unless the board supports voltage control.
Yes, the 80 x 80 x 25 mm dimensions match the common 80 mm mounting pattern used by older fans.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?