Vszerda KZ4476 4-pin Molex to 5 SATA power cable 18AWG 40cm
Adapts one 4-pin Molex connector to five 15-pin SATA power ports using 18AWG wire over a 40cm length
- Converts one Molex connector into five SATA power ports
- 18 AWG wire handles high-current loads for multiple drives
- 40 cm length reaches drives across standard chassis layouts
- Supports HDD and SSD power connections in mining rigs
- Model KZ4476 identifies this specific adapter configuration
Molex to 5 SATA power adapter
The Vszerda KZ4476 cable converts a single 4-pin Molex connector into five 15-pin SATA power ports. It uses 18AWG wire and spans about 40cm, making it suitable for powering multiple hard drives or SSDs from one rail. Miners and builders expanding drive counts will find it a compact solution.
Check your power supply connectors
Ensure the PSU has an available 4-pin Molex output before ordering. Verify that each target drive accepts a standard 15-pin SATA power plug. The 18AWG conductors are rated for typical drive currents, but total draw across all five ports must stay within the Molex rail limit.
Fits tight drive cages and mining frames
At roughly 40cm the lead reaches drives in stacked bays without excess slack. Five SATA heads let one cable serve a small array, freeing other Molex lines for fans or lighting. The straight connectors keep the loom narrow for clean routing behind motherboard trays.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $10.99
- Cheaper than about 70% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What connectors come on the cable and do I need any extra parts?
The cable has one 4-pin Molex plug and five 15-pin SATA power connectors. No additional adapters are required to run five SATA drives from a single Molex outlet.
Which wire gauge should I choose for my build?
This model uses 18AWG wire, which is the only gauge offered for the KZ4476. It is rated for standard SATA power loads in desktop PCs and mining rigs.
Will the 40 cm length reach drives in a full-tower case?
The bus length is about 40 cm from the Molex plug to the last SATA connector, so it suits typical mid-tower layouts; measure your drive bay spacing to confirm.
More in Internal PSU & Riser Cables
Similar items
Nippon Labs POW-04412 12" Molex 5.25 Female to Female internal power cable
- 1 ft (0.3 m)
- Multi-Color
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Ruth's sister JEYI Heat Sink 7mm Ultra-thin Solid State Hard Disk Heatsink internal power cable
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





