Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects SAS devices with a 36-pin SFF-8087 male Mini-SAS plug on each end, supporting 6.0 Gbps over a 1-metre length using 30 AWG wires
This Mini SAS SFF-8087 cable connects RAID controllers, backplanes or host-bus adapters inside workstations, servers and rack-mounted systems. Each end carries a 36-pin male plug with a locking latch so the link stays seated during vibration or chassis movement. The 1 metre length suits typical internal routing without excess slack.
Rated for 6.0 Gbps per lane, the cable maintains that bandwidth across the full 1 metre run rather than only in short bursts. The 30 AWG conductors keep signal loss low enough for continuous RAID rebuilds, parity checks or bulk data migrations without throttling. Shielding and the latch design reduce intermittent errors that can appear when lesser cables heat up under load.
The 30 AWG wire gauge balances flexibility for tight routing with the mechanical strength needed for repeated insertion cycles. Both SFF-8087 connectors feature a positive locking latch that clicks audibly, preventing accidental disconnection during drive-swap operations or chassis maintenance. The assembly is supplied as a single 1 metre unit ready for internal deployment.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The 30 AWG conductors carry the 6.0 Gbps SAS signal without active components, so the cable itself does not generate measurable heat or increase power consumption during all-day operation.
Each end terminates in a 36-pin SFF-8087 male Mini-SAS plug with a locking latch, so the host and target devices must each present a matching SFF-8087 receptacle.
Yes — the 6.0 Gbps cable is backward compatible with 3 Gbps SAS devices, and the 1 metre / 3.3 ft length stays well within the electrical limits for both speeds.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?